How To Reset Replace Drum Message On Brother Printer

How To Reset Replace Drum Message On Brother Printer. About press copyright contact us creators advertise developers terms privacy policy & safety how youtube works test new features press copyright contact us creators. Open the front cover and remove toner & drum from the printer.

How To Reset Replace Drum Message On Brother Printer
18002138289 Fix Drum Error in Brother Printer from slides.com

Install the toner & drum back into the printer. Brother strongly recommends that customers use. About press copyright contact us creators advertise developers terms privacy policy & safety how youtube works test new features press copyright contact us creators.

Read More

Clean The Corona Wire Inside The Drum Unit By Gently Sliding The Green Tab From Left.

Firstly, switch on your printer. Press and hold the go button for 4 seconds or until all four leds light. One way is to use the front panel of the printer.

Brother Strongly Recommends That Customers Use.

Unpack the new drum unit. If you reset the drum counter during the life of the drum unit currently being used, the remaining drum life will not be displayed accurately. Press the up arrow key.

By Replacing The Drum You Are Actually Cleaning Up The Printers Workspace As Well.

Reset dr420 for brother hl printer models. Reinstall the new drum unit, keeping the front cover open. The option is only available when machine has the 'replace drum' or 'drum stop' message.

Select The Toner Color For The Drum Unit You Have Just Replaced, Then Press “Yes”.

How to replace the drum unit: Open the front cover of the printer, and press the ‘ clear ’ button. Press and hold “four color bar” for 5 seconds.

To Do This, Press And Hold The Go Button For About Five Seconds.

Then release the button and press it again. Open the front cover and remove toner & drum from the printer. A quick easy guide on how to reset the drum unit needs replacing message on a brother printer.

Leave a Reply

Your email address will not be published. Required fields are marked *